Filter
Top Products
5
WARNING: THE ACCUMULATION OF LINT IN THE EXHAUST DUCT WORK CAN CREATE
A POTENTIAL FIRE HAZARD.
WARNING: Do not obstruct the flow of combustion and ventilation air. Check customer furnished back
draft damper in exhaust duct work. Inspect and remove any lint accumulation which can
cause damper to bind or stick.
NOTE: A back draft damper that is sticking partially closed can result in slow drying and shutdown of the
heat circuits safety switches or thermostats.
NOTE: When cleaning dryer cabinets, avoid using harsh abrasive. A product intended for cleaning
appliances is recommended.
B. Adjustments
Seven Days after Installation and every 6 Months
Inspect bolts, nuts, screws (bearing set screws), nonpermanent gas connections (union, shut-off valves, orifices,
and ground connections). Motor and drive belts should be examined. Cracked or seriously frayed belts should be
replaced. Tighten loose V-belts when necessary. Complete operational check of controls and valves. Complete
operational check of all safety devices (door switch, lint drawer switch, sail switch, burner and hi-limit thermostats).
C. Lubrication
The motor bearings, idler bearings, and basket (tumbler) bearings are permanently lubricated. No lubrication is
necessary.
The impeller (fan) shaft bearing should be lubricated every three (3) months.