Filter
Top Products
44
5. L.E.D DISPLAY INDICATOR NUMBER 5
a. Air Jet Circuit - OPTIONAL
1.This indicator dot is on at the end of the dryer cycle for approximately 60 seconds.
C. PHASE 6 OPL MICROPROCESSOR CONTROLLER RELAY OUTPUT L.E.D. INDICATORS
There are a series of five (5) L.E.D. indicators (ORANGE LIGHTS) located at the backside are of the Phase 6
OPL microprocessor controller (computer). These are identified or labeled (from top to bottom in the illustration
below as: FAN-BLOWER, FOR-FORWARD, REV-REVERSE, AIR-AIR-JET, HT1-HEAT OUTPUT. There
are a series of seven (7) L.E.D. indicators (red lights) FUSE-MAIN FUSE, LINT-LINT DOOR, MAIN-MAIN
DOOR, DRUM-TUMBLER HI-LIMIT, SAIL-SAIL SWITCH, BURN-BURNER HI LIMIT, FLAME-FLAME
PROBE). The L.E.D. in the center of the board (red light) indicates power supplied to the Phase 6 OPL
microprocessor controller (computer). These L.E.D.'s indicate the inputs and outputs of the Phase 6 OPL
microprocessor (computer) as it monitors the safety circuits.