Filter
Top Products
34
8. Retighten motor mount bolts and jam nuts.
9. Assemble front panel lint door assemblies back to dryer.
10. Reestablish power to dryer.
To Replace Drive Motor V-Belts
1. Discontinue power to the dryer.
2. Remove front panel. Follow front panel replacement instructions on page 27.
3. Loosen tension on v-belt so that it can easily be rolled off pulley. This can be done by loosening the four
bolts holding the motor to the side of the dryer. As well as the adjustment bolt on top.
4. Replace v-belt.
5. Retighten v-belt and adjust tension and alignment per
previous instructions.
J. Motors
To Replace Drive Motor
1. Discontinue power to dryer.
2. Remove front panel from dryer. Follow front
panel replacement instructions on page 27.
3. Remove drive belt.
4. Disconnect wiring harness from motor.
5. Remove bolts holding motor to mount
and replace with new motor. Do not
tighten bolts.
6. Remove pulley from old motor and install on
new motor. By removing the set screw from
the drive motor pulley.
NOTE: A gear puller may be required to
remove pulley.
7. Align motor pulley with drive assembly pulley and tighten set screw holding motor pulley.
8. Replace belts and adjust belt tension.
9. Retighten bolts.
10. Reestablish power to dryer.
To Replace Impeller Motor (Fan Shaft Drive)
1. Discontinue power to the dryer.
2. Remove lint door and front panel from dryer.
3. Remove the perforated panel inside the basket (tumbler).
4. Remove the wrapper assembly under the basket.