Filter
Top Products
25
CAUTION: Do not abort this switch by taping or screwing sail switch damper to burner. PERSONAL
INJURY OR FIRE COULD RESULT.
E. Front Panel and Main Door Assemblies
To Replace Main Door Switch
1. Discontinue power to dryer.
2. Open main door.
3. Remove the two (2) Phillips head screws holding the main door switch bracket assembly in place.
4. Disconnect wiring from switch assembly.
5. Reverse this procedure for installing new door switch assembly.
6. Reestablish power to dryer.
IMPORTANT: Under no circumstances should the door switch be disabled.
To Replace Main Door Assembly
1. Open main door.
2. Holding the door upward remove the two (2) screws from the top hinge block.
3. Lift the door up to remove.
4. Reverse this procedure for reinstalling new main door assembly.
To Install New Main Door Glass as of October 24, 1997
1. Remove main door assembly from dryer (follow main door removal procedure).
2. Lay main door on flat surface with the back of the door facing down.
3. Remove the four 10-32 acorn nuts securing the glass to the door.
4. Remove glass and clean all old sealant off main door. This area must be clean for correct bonding.
5. Place a bead of silicone around the edge door and lightly press glass into place.