Filter
Top Products
29
10. Remove the pulley and key.
NOTE: A gear pulley may be required to remove the pulley.
11. Remove cap screws from bushing.
12. Insert cap screws in the tapped removal holes and tighten evenly until bushing becomes loose on shaft.
13. Remove the bushing, tumbler wheel and key.
14. Reverse this procedure for replacement.
IMPORTANT: Tighten screws evenly and progressively. Never allow the sheave to be drawn in
contact with the flange of the bushing. This gap should measure from 1/8" to 1/4".
Proper cap screw torque is 30 ft-lbs. If greater tightening forces are applied, excess
pressure will be created in the hub of the mounted sheave which may cause it to crack.
Tumbler Wheel Replacement on Drive Assembly (transtorque models)
1. Discontinue power to dryer.
2. Remove front panel from the dryer. (Follow front panel replacement directions on page 27.)
3. Remove the ten (10) 1/4-20 x 1/4" socket button head screws from the perfed basket side.
4. Remove wrapper assembly.
5. Loosen v-belts. Rotate pulley and v-belts out of groove on the pulley. For a more detailed description,
follow steps replacement of drive belt.
6. Block the basket (tumbler) assembly in position.
7. Mark the position of the pillow block bearings, then remove the bolts from the pillow block bearings.
8. Remove the drive shaft assembly through the front of the machine.
9. Remove the set screw from the 9" pulley.
10. Remove the pulley and key.
NOTE: A gear pulley may be required to remove the pulley.
11. Remove the transtorque from the wheel assembly.