Filter
Top Products
28
5. Reestablish power to dryer.
F. Pulleys
To Replace Drive Shaft Pulley
1. Discontinue power to dryer.
2. Remove front panel from dryer (Follow front
replacement directions on page 27.)
3. Loosen v-belts. Rotate pulley and roll v-belts
out of grooves.
4. Remove set screw from the 9" pulley.
5. Remove pulley and key.
NOTE: A gear puller may be required to
remove pulley.
6. Reverse this procedure for replacement.
NOTE: Pulley must be aligned for proper
operation.
To Replace Drive Motor Pulley
1. Discontinue power to dryer.
2. Remove front panel from the dryer. Follow front panel replacement directions on page 27.
3. Loosen v-belts. Rotate pulley and roll v-belt out of groove.
4. Remove set screw from the drive motor pulley.
5. Remove pulley and key.
NOTE: A gear puller may be required to remove pulley.
6. Reverse this procedure for replacement.
NOTE: Pulleys must be aligned for proper operation.
Tumbler Wheel Replacement on Drive Assembly (taper lock models)
1. Discontinue power to dryer.
2. Remove front panel from dryer. (Follow front panel replacement directions on page 27.)
3. Remove the ten (10) 1/4-20 x 1/4" socket button head screws from the perfed basket side.
4. Remove wrapper assembly.
5. Loosen v-belts. Rotate pulley and v-belts out of the groove.
6. Block the basket (tumbler) assembly in position.
7. Mark the position of pillow block bearing then remove the bolts from the pillow block bearings.
8. Remove the drive shaft assembly through the front of the machine.
9. Remove the set screw from the 9" pulley.