Filter
Top Products
27
7. The door assembly should now be put in an area where it will not be disturbed for a few hours. This
will give the silicone a chance to harden.
NOTE: Once the silicone is cured you may want to trim any excess silicone on the inside of the main
door assembly.
8. After the curing period install the main door on the dryer by reversing step no. 1.
To Install new Main Door Glass prior of October 24, 1997
1. Remove main door assembly from dryer (follow main door removal procedure).
2. Lay main door on flat surface with back of door face down.
3. Remove glass and clean all old sealant off main door. This area must be completely clean for correct
bonding.
4. Apply a narrow bead of silicone (ADC P/N 170730) all around main door area where glass will rest.
5. Install glass onto door and adhesive. Slightly press glass into place.
IMPORTANT: Do not press hard or silicone thickness between the glass and door will be reduced, resulting
in poor bonding.
NOTE: Once the silicone is cured you may want to trim any excess silicone on the inside of the main door
assembly.
6. After the curing period install the main door on the dryer by reversing step #1.
To Replace Front Panel
1. Discontinue power to dryer.
2. Remove bottom lint door assembly.
3. Disconnect the four emergency stop wires located in the front left electrical box.
4. Remove the front panel by removing the screws.
IMPORTANT: When pulling the front panel off, the door switch harness in the upper right hand
corner must be unplugged.
NOTE: The main door assembly can be removed to make the panel removal easier. Refer to
"replace main door assembly" directions.
5. Disconnect the emergency stop assembly from the old panel and reinstall on the new panel.
6. Disconnect other door switch wiring switch from the old panel and reinstall on the new front panel.
7. Reinstall the new front panel by reversing steps 1 through 3.
8. Reestablish power to dryer.
To Replace Main Door Hinge Block
1. Discontinue power to dryer.
2. Follow procedure for removal of main door assembly for top hinge removal.
3. Remove the two screws from the bottom hinge block.
4. Reassemble by reversing removal procedure.