Filter
Top Products
54
8. Microprocessor
A. Replace the temperature sensor underneath the basket on a bracket (the bullet shaped device).
B. If it still read "TEMP SENSOR FAIL CHECK TEMP SENSOR FUSE, "unplug J3 4-pin connec-
tor from the temperature sensor bracket. Also, unplug the microprocessor J14 4-pin connector
from the computer board. Take a continuity reading from J14 no. 1 to J3 no. 1, then from J14 no.
2 to J3 no. 2.
If there is no continuity, check for break in wire, a short to the ground, loose terminations, or even
replace the wire.
If there is continuity, computer board is faulty.