Filter
Top Products
30
NOTE: One wrench must be on the transtorque and one on the axle. The wrench on the transtorque
should have pressure applied in a counterclockwise direction.
12. Remove the bushing trantorque and tumbler wheel.
13. Reverse these procedures for replacement.
Tumbler Wheel Replacement on Idler Assembly (taper lock models)
1. Disconnect power to the dryer.
2. Remove the front panel from the dryer. (Follow front panel replacement directions on page 27.)
3. Remove the ten (10) 1/4-20 x 1/4" socket button head screws from the perfed basket side.
4. Remove the wrapper assembly.
5. Block the basket tumbler assembly in position.
6. Mark the position of the pillow block bearings. Then remove the bolts from the pillow block bearing.
7. Remove the idler shaft assembly through the front of the machine.
8. Remove the cap screws from bushing.
9. Insert cap screws in the tapped removal holes and tighten evenly until bushing becomes loose on shaft.
10. Remove the bushing, tumble wheel and key.
11. Reverse this procedure for replacement.