Filter
Top Products
504509 7
Dryer Slide Extension
(Coin Slide Models Only)
Remove two slide extensions, four screws and
lockwashers from the accesssories bag and install the
extension on the top of the coin slide.
IMPORTANT: Slide extension must be attached to
top side of the coin slides to make them long enough to
activate the accumulator (dryer) or timer (washer).
NOTE: This unit, as shipped from the factory, does
not include the coin slides, coin drawers, lock or keys.
These coin slide kits (or parts) must be ordered, at
extra cost, according to the purchaser’s requirements
direct from the coin kit manufacturer of your choice.
Timer Cams
The dryer timers are factory equipped with a 45 minute
timing cam. If this drying time is not suitable to your
installation, the following cams can be found in the
accessories bag.
ELECTRIC DRYERS
1-53242 Cams (30 Minutes)
1-53240 Cams (60 Minutes)
GAS DRYERS
1-53242 Cams (30 Minutes)
A 60 minute timing cam, Part No. 53240, is available for
the gas dryers as optional equipment at extra cost.
Coin Slide Guards
(Coin Slide Models Only)
Using serrated hex head screws from accessories bag,
install coin slide guards (located in accessories bag), to
front of control cabinet. See illustration.
A special security screw kit is available (as optional
equipment at extra cost) for securing the two coin slide
guards and both front access panels to front of unit. Order
Security Kit No. 298P3. A special driver, part number
56217, is available (as optional equipment at extra cost)
for installing the special security screws.
NOTE: Coin slides and coin drawers are shown for illustration only. You must obtain them locally.
. . .
. . .
. . .
COIN
SLIDE
GUARD
COIN
SLIDE
GUARD
SERRATED
HEX HEAD
SCREWS
SERRATED
HEX HEAD
SCREWS
H151IE2A