Filter
Top Products
504509 19
Washer
Electrical Requirements
(120 Volt, 60 Hertz with 3-Prong Grounding Plug)
NOTE: The wiring diagram is located behind the
control panel, inside the control cabinet.
Grounding Instructions
The washer must be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least
resistance for electric current. The washer is equipped
with a cord having an equipment-grounding conductor
and a 3-prong grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided with the washer—if it
will not fit the outlet, have a proper outlet installed by a
qualified electrician.
NOTE: Have a qualified electrician check the polarity
of the wall receptacle. If a voltage reading is measured
other than that illustrated, the qualified electrician
should correct the problem.
Do not operate other appliances on the same circuit when
this appliance is operating.
Do not operate both a washer and gas dryer on the same
circuit. Use separately fused 15 Amp circuits.
. . .
To reduce the risk of fire, electric shock,
serious injury or death, all wiring and
grounding MUST conform with the latest
edition of the National Electrical Code, ANSI/
NFPA No. 70, and such local regulations as
might apply. It is the customer’s
responsibility to have the wiring and fuses
checked by a qualified electrician to make
sure the laundry room has adequate
electrical power to operate the washer.
W227
WARNING
D009IE1A
DO NOT OVERLOAD CIRCUITS
DO NOT USE ADAPTER
DO NOT USE AN EXTENSION CORD
Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. Check with a qualified
electrician or serviceman if you are in doubt
as to whether the washer is properly
grounded.
W032
WARNING
D090IE1A
STANDARD 120 VOLT, 60 HERTZ,
3-WIRE EFFECTIVELY GROUNDED CIRCUIT
NEUTRAL
SIDE
ROUND
GROUNDING
PRONG
GROUND
NEUTRAL
L1
0
V.A.C.
120 ± 12
V.A.C.
120 ± 12
V.A.C.
To reduce the risk of electric shock or fire, DO
NOT use an extension cord or an adapter to
connect the washer to the electrical power
source.
W031
WARNING