Filter
Top Products
14 504509
Step 8:
Position and Level the Unit
Place unit in position on a clean, firm and reasonably
level floor. Installing the unit on any type of carpeting is
not recommended.
Loosen 9/16" locknuts and adjust the leveling legs until
the unit does not rock and is level from side-to-side and
front-to-back. Hand tighten locknuts against unit base
and then securely tighten locknuts with 9/16" deep well
socket wrench. If the locknuts are not tight, the unit will
move out of positon during operation.
NOTE: Level must rest on raise portion of top panel.
See illustration.
Remove rubber feet from accessories bag and place on all
four leveling legs.
NOTE: For further assistance, refer to Section on
Location Requirements.
DO NOT slide unit more than four feet across
floor if the leveling legs have been extended,
as legs and base could become damaged.
W184
CAUTION
Use of the dispenser drawer or washer or
dryer doors as handles in the transportation
of the unit may cause damage to the
dispenser or doors.
W185
CAUTION
H234IE1A
LEVEL
LEVELING
LEG
LOCKNUT
WASHER
BASE
RUBBER
CUP