Filter
Top Products
504509 49
User-Maintenance Instructions
Lubrication
All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Cold Weather Care
If the washer is delivered on a cold day (below freezing),
or is stored in an unheated room or area during the cold
months, do not attempt to operate it until the washer has
had a chance to warm up.
Vacations and Extended
Non-Use
IMPORTANT: To avoid possible property damage
due to flooding, turn off the water supply to the
washer whenever there will be an extended period of
non-use.
Care of Your Washer
Use only a damp or sudsy cloth for cleaning the control
panel. Some cleaning product sprays may harm the finish
on the control panel or damage the interior of the hood.
Wipe the washer cabinet as needed. If detergent, bleach
or other washing products are spilled on the cabinet, wipe
immediately. Some products will cause permanent
damage if spilled on the cabinet.
Do not use scouring pads or abrasive cleansers.
Do not lay sharp or rough objects on or against the
washer. The finish could be damaged.
The wash drum and window will need no particular care
although they may need rinsing or wiping after an
unusual load has been washed. Outside of window can be
cleaned with household window cleaner.
Care of Your Dryer
Clean the lint filter before drying each load. The lint filter
may be washed if needed. Occasionally remove lint filter
and vacuum the area under it.
Ordinarily, the dryer cylinder will need no care.
Wipe each dryer cabinet as needed. If detergent, bleach or
other washing products have been spilled on the dryer
unit, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Do not allow sharp or rough objects to lean against the
dryer unit. The finish could be damaged.
Use only a damp or sudsy cloth for cleaning the control
panel. Some spray prewash products may harm the finish
on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
Exhaust System
The exhaust duct should be inspected after one year of
use and cleaned if necessary by a qualified service person
to remove any lint build-up. Inspect and clean exhaust
duct every one to two years as required thereafter.
The weather hood should be checked frequently to make
sure the dampers move freely, dampers are not pushed in
and that nothing has been set against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors and
liquids.
Do not obstruct the flow of combustion and ventilation
air.
NOTE: Verify proper operation after servicing.
. . .
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
W049
CAUTION