Filter
Top Products
8 504509
Before You Start
Tools
For most installations, the basic tools you will need are:
Water
Washer needs two standard 3/4 inch (19.1 mm) water
supply faucets with a pressure between 20-120 pounds
per square inch (138 to 827 kPa). For more detailed
information, refer to Section on Water Supply
Requirements.
Exhaust
Use rigid metal duct and exhaust the dryer to the outside
by the shortest route possible.
NOTE: For more detailed information, refer to
Section on Dryer Exhaust Requirements.
Electrical
• WASHER
Refer to Serial plate for specific electrical
requirements. For more detailed information, refer to
Section on Washer Electrical Requirements.
• ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt, 60
Hertz, AC single Phase electrical supply. For more
detailed information, refer to Section on Electric
Dryer Electrical Requirements.
• GAS DRYER
Dryer needs a 120 Volt, 60 Hertz, polarized 3-slot
effectively grounded receptacle. For more detailed
information, refer to Section on Gas Dryer Electrical
Requirements.
NOTE: 208 Volt heating element is available (as
optional equipment at extra cost).
Gas
Dryer is equipped for Natural Gas with a 3/8" NPT gas
supply connection. For more detailed information, refer
to Section on Gas Requirements.
Location
Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to Section on
Location Requirements.
. . .
D074IE1G
LEVEL
SCREWDRIVERS
PLIERS
WRENCH
9
/
1
6
"
SOCKET
WRENCH
DUCT TAPE
TEFLON TAPE
H092IE1A