4 ADVANCED FEATURES
1-6 Polling Transmission
This feature allows you to leave a document in the feeder fora remote terminal to pick up (polling can-
not be done from memory). Reception can take place as normal after you have set up a polling trans-
mission.
Note: Polling transmission can be either free or secured.
Free polling –
Secured polling –
ID codes will not be checked. Any terminal can poll yours.
ID codes will be checked. If a machine with a different ID code tries to poll
your terminal, it will not succeed.
For extra security, you can specify an ID code for this message. The other
end will have to enter this code to pick up the message, instead of their
programmed ID code.
ID code, page 23.
1.
Make sure that the unit is in
6. Type in the ID code that you wish
standby mode.
to use for this message.
Example: 7 3 6 2 .
2.
3.
READY
100’% 02 30PM
SET DOCUMENT
Press polling NO . The Polling
READY 100% 02 30PM
ID 7362
YIN
Press No if you make a mistake.
indicator should be lit.
7. Press Yes to confirm this
Place a document in the feeder.
Select contrast and resolution.
READY
100% 02 30PM
PAGES 00
KEYPAD/N
4. Press NO twice.
5.
Page counting, page 35.
Department Code, page 36.
READY
100’% 02 30PM
PERSONAL I D? YIN
Either:
If you do not wish to specify an ID code
for extra security, press No .
Go to step 8.
Or:
For extra security, press Yes .
Go to step 6.
D.
The other end must use this code
to pick up the message. Go to
step 9.
8.
READY
100% 02 30PM
CHECK I D CODE?
YIN
Either:
● press Yes
to select secure polling.
. Press No to select free polling.
9. Your terminal is now in polling
standby. When your terminal is
polled, it will scan and transmit
the document.
To cancel polling standby, open
the scanner and remove the
document.
READY
100% 02 30PM
I D ¤~~~ KEYPAD
57
