2 INSTALLATION
3-6 Programming Your Fax Terminal’s Telephone Number
If you do not program this number, you will not be able to use Transfer Request. This is because the
broadcasting terminal needs your number to send back the Transfer Result Report.
1.
Make sure that the unit is in
4. Press
Yes to store the num-
standby mode.
her.
READY
100% 02 30PM
SET DOCUMENT
z. Pl@SS ,_Function 8 j LO I Yes .
.—.
See Note 1
3. Enter your terminal’s number at
the keypad, in the following order:
i) International dial access code (01 1
in the U.S.A.)
ii) Country code (1 in the U.S.A.)
iii) Area code (e.g., 213)
iv) Press Pause/Redial .
v) Tel. number (e.g., 5556837)
~
See Note 2
To correct errors:
. Press : No , to clear the display
and re-enter the number.
● Press [ Clear I to erase the last
digit only.
Notes:
1. If a number had already been pro-
grammed, either:
—.
● Press Yes to accept it.
● Press ; Clear ] to erase it.
2. You have to entera pause after the area
code.
See Note.
Note
If PLEASE SET PAUSE is displayed,
you did not enter a pause. Reprogram
the number from step 3.
