7 SOLVING PROBLEMS
3. LINE PROBLEM
If the Line Fail indicator is blinking there was a line problem.
A poor line caused the communication to fail. Wait for the Communicating indicator to go out.
Then press 1Stop I .
Check your copy tray for an Error Report.
4. OPERATING DIFFICULTIES
STANDBY MODE
READY
100% 0230PM
SET DOCUMENT
I
The above ‘READY’ message is not shown
on the display panel.
TRANSMISSION
The machine cannot dial out.
The machine cannot dial out from behind a
PBX.
Transmission cannot take place; Clear
Original indicator blinks.
Transmission cannot take place; Line
Fail indicator blinks.
The document is not pulled into the ADF.
RECEPTION
The telephone keeps ringing and no fax is
printed.
● Switch the power on. If the Power indica-
tor does not light, check that the power
cord is plugged in.
. Change the telephone line type setting
(see page 19).
. The number must contain the access
code and a pause (see page 81). Try
adding more pauses.
. The document is jammed in the feeder.
Remove the jammed document
(see page 112) and repeat the
transmission procedure.
. The document may be longer than the
maximum limit (see Recommended
Types of Document).
. The other machine is out of order.
Check the error report.
Ask the other party to correct the fault.
. The line is busy or noisy.
Check that the dial tone is sent out.
Try to retransmit.
. Insert the document into the feeder
until it stops. Retransmit.
● You are in Manual Receive mode.
Change to Automatic Receive mode
(see page 42).
. Power is switched off.
118
