Filter
Top Products
6-10
NOTE: Be sure to perform the Diagnostic Tests
before replacing the control board.
To remove Central Control Unit (CCU):
1. Unplug washer or disconnect power.
2. Remove all connectors from the CCU.
3. Place two flat blade screwdrivers under the
left and right tab, on the top of the CCU and
slide the CCU forward.
To reassemble CCU:
1. Align the tab on top of the CCU with the
notch in the cabinet. Also, align the posts on
the back of the CCU with the hole in the
back of the cabinet.
2. Slide the CCU back into place.
3. Reconnect wire harness.
IMPORTANT: Electrostatic (static electric-
ity) discharge may cause damage to elec-
tronic control assemblies.
CONTROL BOARD REMOVAL
OR REPLACEMENT
To remove the touchpad/LED assembly:
1. Unplug washer or disconnect power.
2. Disconnect touchpad/LED assembly wire
harness from the CCU.
3. Remove dispenser drawer.
4. Remove left front screw that was covered
by the dispenser drawer.
5. Open door, under the center of the touchpad/
LED assembly there is a notch, insert a flat
blade screwdriver in notch to release the
bottom of the touchpad/LED assembly.
6. On the right hand side behind the touchpad/
LED assembly, press tab to release right
side of the touchpad/LED assembly.
7. Gently pry up and release the top of the
touchpad/LED assembly. This should com-
pletely release the entire touchpad/LED
assembly.
To remove Motor Control Unit (MCU):
1. Unplug washer or disconnect power.
2. Remove wire harness cover and discon-
nect the wire harness from the MCU.
3. With a flat blade screwdriver, lift the front
tab up and slide the MCU forward.
To remove line/ interference filter:
1. Unplug washer or disconnect power.
2. Disconnect the three connectors from the
line filter and power cord.
3. Remove the two screws which secure the
line filter to the top brace.