Filter
Top Products
4-14
REMOVING THE MOTOR CONTROLLER
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the three T-20 hex-head torx
screws from the toe panel and remove the
panel.
4. Open the wiring access door on the front
of the motor controller housing.
5. Disconnect the four wire connectors from
the motor controller. NOTE: Each connec-
tor has a locking arm or locking tabs that
you must release to remove the connector
from the unit.
6. Cut the wire tie and pull the cut tie out of the
slot in the standoff. NOTE: Be careful not
to cut any of the wires in the tie.
7. Lift the locking tab on the motor controller
housing, and slide the housing tabs for-
ward as far as they will go.
8. Lift the motor controller housing so the
tabs are out of their chassis slots, and
remove the housing from the washer.
Motor Controller
Wiring
Access
Door
Cut
Wire
Tie
2-Wires
Grn/Yel
4-Wires
3-Wires
Lift Housing Tab
Motor Controller Housing
Screws
Toe Panel