Filter
Top Products
4-11
REMOVING THE CENTRAL CONTROL UNIT
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
(see page 4-2 for the procedures).
4. Remove all of the wire connectors from
the central control unit (see the photo at
the top of the right column). NOTE: Each
connector has a locking arm or locking
tabs that you must release to remove the
connector from the unit.
6. Pry up on the two end locking tabs with a
small screwdriver and unhook the central
control unit from the washer.
Central Control Unit
5. Unlock the two wire clips and remove the
wires from each of the clips (4 total).
Locking Tabs
Central Control Unit