Filter
Top Products
5-6
INTERLOCK SWITCH
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Actuator
Refer to page 4-20 for the procedure for servic-
ing an interlock switch.
1. Unplug washer or disconnect power.
2. Disconnect the wires from the interlock
switch terminals.
3. Set the ohmmeter to the R X 1 scale.
4. Touch the ohmmeter test leads to the two
interlock switch terminals. The meter
should indicate an open circuit with the
actuator in, and a closed circuit (0 Ω) with
the actuator out.
DRIVE MOTOR
Refer to page 4-22 for the procedure for servic-
ing the drive motor.
1. Unplug washer or disconnect power.
2. Disconnect the wire connector from the
drive motor terminals.
3. Set the ohmmeter to the R x 1 scale.
4. Touch the ohmmeter test leads to the
following drive motor terminals. The meter
should indicate between 3 and 8 Ω.
Terminals 1 & 2
Terminals 1 & 3
Terminals 2 & 3
NOTE: Terminals 4 and 5 are for the tachom-
eter.
(Connector viewed From Wire End)
1
2
3
4
5