Whirlpool MFW 9700S Washer User Manual


 
3-9
Put the separator in the front position,
between the guides, as shown following. There will be no gap
between the bottom of the wash cycle detergent
compartment and the bottom of the separator.
Put the separator in the back position,
behind the guides, as shown following. There will be a gap
between the bottom of the wash cycle detergent
compartment and the bottom of the separator.
The separator will be in the POWDER (back) position
w
hen shipped from the factory.
12345678938294587
(
Letter E in Dispenser Illustration)
A
dd no more than 1/3 Cup (80 mL) liquid chlorine bleach to this
c
ompartment. The bleach will be automatically diluted and
dispensed at the optimum time during the first rinse after the
w
ash cycle. This compartment cannot dilute powdered bleach.
Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess.
Do not fill beyond the MAX level. Overfilling could cause
severe garment damage.
569 4878594587
(
Letter F in Dispenser Illustration)
A
dd ¼ cup (60 mL) liquid fabric softener to this compartment.
F
abric softener will be automatically dispensed in the final rinse.
Do not fill beyond the MAX level.
 679 459 8567
To pause the washer at any time, select PAUSE/OFF.
To continue the cycle, select HOLD TO START (for
approximately 1 second).
127679138964797946685
Not all Options and Modifiers are available with all cycles. Cycles,
Options and Modifiers can be changed anytime before HOLD TO
START is selected.
Options and Modifiers can be changed anytime after HOLD TO
START is selected and before the start of the selected Option or
Modifier.
Select PAUSE/OFF twice.
Select desired cycle.
Select the desired OPTIONS.
Select HOLD TO START (for approximately 1 second) to
restart the washer at the beginning of the new cycle.
Select PAUSE/OFF twice.
The washer powers down, the door unlocks, and clothes can
be removed.
If the water level or the temperature is too high, the
washer will drain automatically before the door unlocks.
Select PAUSE/OFF.
Select the desired OPTIONS or MODIFIERS.
Select HOLD TO START (for approximately 1 second) to
continue the cycle.
Select PAUSE/OFF.
Select DRAIN/SPIN.
Select HOLD TO START (for approximately 1 second) to
begin the drain.
When the spin is complete, the door unlocks. Items can be
removed from the washer.
962
These lights show which portion of the cycle the washer is
operating. They also indicate when you can add an additional
item to the wash cycle and when the controls are locked.