Filter
Top Products
3-15
1
2345678265
89771
8977
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
8977
To keep the interior of your washer clean, run the Sanitary cycle
without clothes. Use ½ of the detergent manufacturer's
recommended amount of High Efficiency (HE) powdered or liquid
detergent for a medium-size load.
897779
Check the fold of the seal periodically for any foreign objects. To
clean the seal, mix a dilute solution, using ¾ cup (177.4 mL) of
liquid chlorine bleach, and 1 gal. (3.8 L) of warm tap water. Wipe
the seal area with the dilute solution, using a damp cloth. Let
stand 5 minutes. Wipe down area thoroughly with a dry cloth and
let the washer interior air dry with door open.
Wear rubber gloves when cleaning for prolonged periods.
Refer to the bleach manufacturer's instructions for proper
use.
89777
The dispenser drawer is removable for easy cleaning.
Unlock the dispenser drawer by pressing the Release Lever in
the Prewash compartment. See Using the Dispenser.
Remove the drawer.
Remove the inserts (the siphon from the softener and bleach
compartments and the separator).
Wash the parts under running water.
Replace the inserts and return the dispenser to the drawer.
1 79 74
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
737778
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
!777"
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
Unplug washer or disconnect power.
Turn off the water supply to the washer. This helps avoid
unintended flooding (due to a water pressure surge) while you
are away.
Slightly open door to provide ventilation.
#7$7"
Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
Run washer on a DRAIN/SPIN cycle.
Unplug washer or disconnect power.
Shut off both water faucets.
Disconnect water inlet hoses from faucets and drain.
#777"
Flush water pipes. Reconnect water inlet hoses to faucets.
Turn on both water faucets.
Plug in washer or reconnect power.
Run the washer through the Normal/Casual cycle with the
manufacturer?s recommended amount of HE detergent for a
medium-size load, to clean the washer and remove the
antifreeze, if used.
#777"
If washer will be moved during freezing weather, put in
1 qt (1 L) of R.V.-type antifreeze in the drum. Run washer on
a DRAIN/SPIN cycle.
Unplug the power cord.
Disconnect the drain hose from the drain system and attach
to rear panel clips.
Shut off both water faucets.
Disconnect the water inlet hoses from faucets, then drain the
hoses and clip them to the rear panel of the washer.
Call service. Do not reuse transport bolts. Washer
must be transported in the upright position. To avoid suspension
and structural damage to your washer, it must be properly set up
for relocation by a certified technician.
69977
Follow the Installation Instructions to locate, level and
connect the washer.
Run the washer through the Normal/Casual cycle with the
manufacturer?s recommended amount of HE detergent for a
medium-size load, to clean the washer and remove the
antifreeze, if used.
1234546