Filter
Top Products
20 / EN
Washing Machine / User’s Manual
4.3.11.3 Adding or taking out laundry
1. Press the Start / Pause button to switch the machine to pause mode. The programme follow-up light of the
relevant step, which the machine was switched into during the pause mode, will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
5. Close the Loading Door.
6. Make changes in auxiliary functions, temperature and speed settings if necessary.
7. Press the Start/Pause button to start the machine.
4.3.12 Child Lock
Use the Child Lock function to prevent children from tampering with the machine. Thus you can avoid any
changes in a running programme.
C
You can switch the machine on and off with the On / Off button when the Child Lock is active. When you switch the
machine on again, the programme will resume from where it stopped.
4.3.12.1 To activate the child lock:
Press and hold the Auxiliary Function button 2 for 3 seconds. In the programme selection display on the
panel, the “Child lock enabled” light will switch on. You can release Auxiliary Function button 2 when this
warning is displayed.
4.3.12.2 To deactivate the child lock:
Press and hold Auxiliary Function button 2 for 3 seconds. In the programme selection display on the panel,
the “Child lock enabled” light will switch off.
4.3.13 Cancelling the programme
The programme is cancelled when the machine is switched off and on again. Press and hold the On / Off
button for 3 seconds.
C
If you press the On / Off button when the Child Lock is enabled, the programme will not be cancelled. You must cancel
the Child Lock first.
If you want to open the loading door after you have cancelled the programme but it is not possible to open the loading door
since the water level in the machine is above the loading door opening, then turn the Programme Selection knob to
the Pump+Spin programme and discharge the water in the machine.
4.3.14 End of programme
The End LED appears on the display when the programme is completed.
If you do not press any button for 10 minutes, the machine will switch to OFF mode. The Display and all
indicators are turned off.
Completed programme steps will be displayed if you press the On / Off button.
4.3.15 Your machine features "Standby Mode".
After you switch on your machine with On-Off button, if no programme is started or no other procedure is
performed at the selection step or no action is taken within approx. 10 minutes after the selected programme
ends, your machine will switch to OFF mode automatically. The Display and all indicators are turned off.
Selected programme data will be displayed if you press the On / Off button. Before you start the program,
check the accuracy of your selections. If necessary, repeat them. This is not an error.