Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Program Menu
33
F8138801
Cycle, Segment and Step
Programming Flow Diagram
Figure 27
Step Menu Navigation
Step Menus are a subgroup of the Modify Cycle Menu
and the navigation is very similar to the navigation of
the Modify Cycle Menu. When a step menu is first
displayed, the step name will be highlighted. While the
step name is highlighted, it can be toggled on or off by
pressing the keypad. If the Step is toggled from
OFF to ON, then the last programmed parameters will
be displayed. The programmable parameters (i.e.,
water temperature, water level, time, etc.) are based on
the step being programmed. For instance, the water
temperature is available in the Fill Step but not the
Reuse Fill Step, so, the water temperature parameter
will not be shown in the Reuse Fill Step.
NOTE: Reuse Fill Step is only available when the
different Step parameters can be selected.
Press the or keypad. To view all steps of a
segment, continue pressing the keypad until the
EOS Audio Step is displayed. Pressing the
keypad again will take screen to Save Changes Menu.
After selection, the cycle modify section is displayed
with highlighted box on segment just viewed/changed.
Pressing the or keypad can adjust the
Step Name and parameters.
To adjust time, the user must press the keypad to
get to the Time Edit Mode. The Time Edit Mode
works exactly like the String Edit Mode. The
and keypads move the cursor between digits.
The and keypads change the number.
Cycle NameCycle Number
Segment Name
Reuse Fill Step
Fill Step
Segment Number
Supply A Step
Supply B Step
Agitate Step
Cooldown Step
Drain Step
Spray Rinse Extract Step
Extract Step
EOS Audio Signal Step
PHM1024R
1
Reuse Fill Step is not used unless active in the Global Settings.
2
Supply B Step will not be shown if Supply A step is turned off.
PHM1024R