Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
27
F8138801
Menu Navigation
The UniLinc
The front-end control allows the user to control
machine operation by pressing keypads to select
options on the display menus and by navigating
between display menus.
The control has four ways to navigate to program, edit,
and select items in menus
Menu Navigation on a Single Screen
The Menu Navigation on a single screen displays a list
of items arranged either left to right and/or top to
bottom on the screen. A highlighted box shows the
selected item in the menu. Press the directional arrow
keypads to move the highlighted box between choices.
Press the keypad to select an item. Press
the keypad to turn an item on or off.
NOTE: In Cycle Menu, the highlighted box
remains in the center, and the cycles scroll as the
directional keypads are pressed.
Menu Navigation with Parameters
Another type of menu similar is a menu with
modifiable parameters. The and keypads
are used to navigate through the screens. The
and keypads are used to change the valve of the
highlighted item.
An example is the Temperature Menu under Global
Setup. The menu items are positioned vertically, but
the and keypads are used to navigate
through the different items while the and
keypads are used to adjust the values.
Screen to Screen Navigation using
the Arrow Keypads
In Screen to Screen Navigation, the or
keypad are used to go from one menu page to the next
(i.e., moving from Alarms [1 of 3] Menu to Alarms
[2 of 3] or Alarms [3 of 3] menus), if a menu cannot fit
entirely on the same page. The Laundry Management
Menu uses this navigation method.
Navigation
The Edit Mode is used when a letter or numeric value
has to be modified or created. The highlighted box is
moved over the editable item and the keypad is
pressed. The mode can be verified by seeing the first
character in the item with a blinking underscore
underneath. The character can then be changed by
using the and keypads.
For example, the Cycle Name can contain the capital
letters “A” through “Z”, small letters “a” through “z”,
the numbers “0” through “9”, and special characters.
The user can go forward to the next character in the
item by using the keypad. Press the
keypad to go backward a character. If the first
character in the item is selected and the keypad
is pressed, the cursor will go to the last character of the
item. Thus, the cursor will move only within the item
when the horizontal keypads are pressed.
Another example of the edit mode is when the user is
programming the time. In the edit mode when
programming a time, the only characters that can be
selected are “0” through “9” when using the
or keypad.