Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
18
F8138801
Machine Cycle Definition and Operation
There are 41 machine cycles which can be selected
and run. Machine cycles can be modified or made
“unavailable” by manually editing them in Modify
Cycle Menu or by using the PDA to download a
modified machine cycle into the control. Machine
cycles cannot be deleted, but can be made
“unavailable” so that they are not visible from the
Cycle Menu. New machine cycles cannot be created,
but existing machine cycles that have been edited to be
“unavailable” may be re-edited to be available again.
Machine Cycle Operation
When a cycle is run, the control runs the cycle
segment by segment and step by step in a sequence.
The first segment can be programmed to “Off”,
“Prewash”, “Wash” or “Rinse”. If the segment is
programmed to “Off”, control skips to the next
segment. If the segment is not programmed to “Off”,
the first segment step (Reuse Fill step) is examined to
see if it is programmed on. If the segment step is
programmed on, it is executed and the next step
follows until the segment is complete. Any segment
steps programmed to “Off” are skipped.
At the start of a machine cycle, the control displays a
Total Remaining Cycle time. This time is taken from
the audit data for this cycle where there is stored an
average time elapsed for the last three of these cycles
that had been completed. The Total Remaining Cycle
Time begins to count down as soon as the cycle is
started. Since there will be differences between the
average elapsed cycle time and the actual elapsed
cycle time, the Total Remaining Cycle Time displayed
is corrected at the start of the cycle’s final enabled step
that has programmed time duration.
Rotation Sensor Equipped
Machines
On machines equipped with rotation sensors and a
rotation sensor error has not occurred, the control
monitors the rotation sensor. The control will never
send a new motor output which would reverse the
motor direction or force the motor to run at a lower
speed if the rotation sensor input indicates that the
machine basket is rotating. The control will wait for
the rotation to stop before sending the motor
command.
Delayed Start Feature
The user can select a machine cycle to run at a later
time. Refer to Delayed Start Menu Section.
Jog Feature UW150 Only
The user can use Jog Feature from the Cycle Menu in
Idle Mode, while the machine door is open. When the
control detects that the jog buttons are pressed, the
control will wake up and start a five second sound,
turn the beeper on and off for five seconds and then the
motor will turn in reverse direction at a reduced speed.
Cycle Menu
The Cycle Menu is the first menu displayed by the
control at power-up. The Cycle Menu allows the user
to select one of the 41 machine cycles. Machine cycles
that are turned off will not be displayed in the Cycle
Menu. As a default, the last run cycle will be displayed
in the center, highlighted position. The factory default
cycle will be Cycle01.
PHM702N
Figure 6
WARNING
To avoid personal injury, do NOT reach
into the basket while it is rotating. Keep
all personnel at a safe distance from the
machine while using the basket Jog
Feature.
W641
For Technical Service
Distributor ABC
1-800-555-5555
Cycle41:
Supply Set
Up
Cycle02:
Towels White
Cycle01:
Towels
White
Bleach
Cycle Menu