Using LXEConnect
Using LXEConnect
1. If an ActiveSync connection is has not been established, connect the MX3X to the PC. Details on ActiveSync are
included in the following section.
2. Double-click the LXEConnect icon that was created on the desktop.
3. LXEConnect launches.
LXEConnect Notice
4. Click the OK button to dismiss the About CERDisp dialog box. The dialog box automatically times out and disappears
after approximately 30 seconds.
LXEConnect Desktop
5. The MX3X can now be configured from the LXEConnect window. Input from the PC’s mouse and keyboard are rec-
ognized as if they were attached to the MX3X.
6. When the remote session is completed, terminate the LXEConnect program by selecting File | Exit or clicking on the X
in the upper right hand corner to close the application then disconnect the ActiveSync cable.
Note: After using LXEConnect, the MX3X cannot go into Suspend mode until after a warmboot. If using Power
Management on a MX3X, always warmboot the MX3X when finished using LXEConnect.
E-EQ-MX3XRG-W-ARC [ 51 ] MX3X Reference Guide
