Bluetooth Beep and LED Indications
Bluetooth Beep and LED Indications
Beep Type from Bluetooth Device Behavior
Acknowledge label 1 beep
Label rejected 2 beeps at low frequency
Transmission error Beep will sound high-low-high-low
Link successful Beep will sound low-medium-high
Link unsuccessful Beep will sound high-low-high-low
LED on Bluetooth Device Behavior
Yellow LED blinks at 2 Hz Linking in progress
Off Disconnected or unlinked
Yellow LED blinks at 50 Hz Bluetooth transmission in progress
Yellow LED blinks at the same rate as the paging beep (1 Hz) Paging
Green LED blinks once a second Disabled indication
Upon startup, if the scanner sounds a long tone, this means the scanner has not passed its automatic Selftest and has entered
isolation mode. If the scanner is reset, the sequence is repeated. Contact LXE Support for assistance.
Easy Pairing and Auto-Reconnect
The Bluetooth module can establish relationships with new devices after the end-user taps the Discover button. It can auto-
reconnect to devices previously known but which have gone out of and then returned within range. Pairing supports SPP
devices only.
Up to two Bluetooth devices can be connected to the MX3X at a time; LXE supports one Bluetooth scanner and one Bluetooth
printer.
Note: Configuration elements are persistent and stored in the registry.
Setup the Bluetooth module to establish how the user is notified by easy pairing and auto-reconnect events.
AppLock, if installed, does not stop the end-user from using the Bluetooth application, nor does it stop other Bluetooth-enabled
devices from pairing with the MX3X while AppLock is in control.
E-EQ-MX3XRG-W-ARC [ 88 ] MX3X Reference Guide
