A SERVICE OF

logo

USB Client Cable
USB Client Cable
Connect from USB-H serial port to USB Type B Male receptacle on a USB hub, camera, etc.
Tethered Scanners
Do not connect a tethered scanner cable to a MX3X’s USB-C or USB-H labeled endcap port. These ports cannot power a
tethered scanner.
Tethered scanners connect to RS-232 labeled ports on the endcap and can connect to the RS-232 port on a powered cradle.
The MX3X Scan buttons have no effect on tethered barcode scanners (connected to a serial port). Tethered scanners read
barcode scans only when the trigger on the tethered scanner is pressed. The tethered scanner requires power on pin 9 of the
mobile device’s serial port.
To set the MX3X to use a tethered scanner, select Start | Settings | Control Panel | Scanner | COM1 (or 2 or 3).
Tap the “Power on Pin 9 (+5V)” checkbox for the COM port selected. The COM port that accepts the scanner data can be
configured for data rate, parity, stop bits and data bits.
E-EQ-MX3XRG-W-ARC [ 13 ] MX3X Reference Guide