Adjusting the Vacuum Strength (VacuumStrngth)
When printing on heavyweight paper or paper that curls or wrinkles easily, if the Printhead rubs against paper, adjusting the
level of suction against paper on the Platen may improve results.
Important
• Paper rubbing against or becoming caught on the Printhead may jam or result in printed documents that are
soiled.
1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Paper Menu is displayed.
3. Press ▲ or ▼ to select Paper Details, and then press the OK button.
4. Press ▲ or ▼ to select the type of paper, and then press the OK button.
Note
• When VacuumStrngth is set to Automatic, the setting value selected for the previous print job is
displayed (to the right of Automatic ) once you select the type of paper currently supplied.
However, the value is cleared when the printer is turned off or the paper is replaced.
5. Press ▲ or ▼ to select VacuumStrngth, and then press the OK button.
6. Press ▲ or ▼ to select the desired setting value, and then press the OK button.
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
Adjusting the Vacuum Strength (VacuumStrngth) iPF6300
7
780
