M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 38 of 38
Analog Input Board Setup
This menu is not used with the Nitrider Control system and should be ignored.
PLC Calibration
This menu is only used with the Nitrider Control system when the PLC is handling the gas flow readings and
control. Contact SSI at 800-666-4330 for assistance with this feature. Press the appropriate button to
select that gas valve – i.e., press H2 for the H2 valve. The selected valve will be displayed at the top of
the screen.
The first section is for the Setpoint Output. All of
the buttons in both sections function identically.
Press the Zero button to set the zero value. The
text above the buttons will read “Enter measured
Zero value (mA) and press calibrate”. Press the
Span button to set the span value. The text above
the buttons will read “Enter measured Span value
(mA) and press calibrate”. Press the Cancel button
to cancel the zero or span process. Press the
Nominal button to set nominal values for the
Setpoint Output. This will display a message box:
“Set nominal zero values. Are you sure?” Press the
Yes button to set the nominal values, or press the
No button to cancel the nominal value set. Press
the Edit button to display a numeric keypad that will
allow the user to edit the zero or span value. This
can range from 0.00 to 32767.00. Press the
Calibrate button to begin the calibration process. This will display a message: “Begin Calibration. Are you
sure?” Press the Yes button to begin the calibration process, or press the No button to cancel the
calibration process.
The second section is for the Flow Input. Press the Zero button to set the zero value. The text above the
buttons will read “Enter observed Zero flow value and press calibrate”. Press the Span button to set the
span value. The text above the buttons will read “Enter observed Span flow value and press calibrate”.
Press the Cancel button to cancel the zero or span process. Press the Nominal button to set nominal
values for the Setpoint Output. This will display a message box: “Set nominal zero values. Are you sure?”
Press the Yes button to set the nominal values, or press the No button to cancel the nominal value set.
Press the Edit button to display a numeric keypad that will allow the user to edit the zero or span value.
This can range from 0.00 to 32767.00. Press the Calibrate button to begin the calibration process. This
will display a message: “Begin Calibration. Are
you sure?” Press the Yes button to begin the
calibration process, or press the No button to
cancel the calibration process.
Press the Done button to return to the
Configuration
menu.
Adam Correction
This menu is only used with the Nitrider Control
system that utilizes an ADAM module for Load
Thermocouples. Contact SSI at 800-666-4330
for assistance with this feature. The ADAM
module offset correction menu option gives the