SSI America 9210 Washer/Dryer User Manual


 
M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 20 of 20
Chapter 3 - CONFIGURATION
Configuration Menu
The Configuration Menu is
entered through the Menu button
that is part of the 6-buttons
running down the right side of the
default status display screen.
Pressing the Login button that is
below the blue Up and Down
arrow buttons displays a numeric
keypad. Enter the correct
passcode for the configuration
level and press the Enter key.
This displays the configuration
menu.
Program Edit
Selecting
Program Edit
displays
another screen, which asks the operator to enter a program number to be edited. Enter 0 to edit a blank
program. To erase/delete an existing recipe/program you need to save it as Program Zero (0). Program 0
is a “NO-OP” program. Depending on the 9210’s security setup and current Login status, the user may be
first prompted to enter a pass code before being allowed to enter a program number to edit.
When you enter a number for a stored program and push the Enter key the program steps are displayed.
Using the up and down arrow keys allow the user select the step in the existing program to edit. Move the
cursor to that step and press the Enter key. The next screen to pop up will show the step’s parameter and
its value.
NOTE: A list of Op-Codes appears in Chapter 5 of this manual
.
Example:
Parameter Value
Opcode SOAK
Time (hh:mm) 3:45
Highlighting the Opcode line and pressing the Enter button brings up a screen that shows all of the
possible Opcodes. Use the Up or Down arrow keys to select the Opcode that you want to use for the
program step that you are editing and press the Enter key. To change the Time option, highlight the line
and press the Enter key. The next screen is the “Time Edit” screen. If you wish to change the hour, press
the Hour button in the upper right-hand corner. If you want to change the minutes press the Min button.
The next screen that pops up in both cases is a numeric keypad. Enter the number of hours or minutes that
you wish to permanently change the recipe to and press the Enter button. If you DO NOT wish to make
any changes press the Esc button.
Press the Set button to save the changes in the program. Notice that the time has been changed on the
program segment that you were editing. If you wish to save this change, press the Save button. You will
notice that a numeric keypad pops up and asks you to enter the number of the program that you wish to
save. It defaults to the program number that you were editing. If this is the program that you wish to save
the change, press the Enter key. If you wish to save this as a new program, press the Clr button on the
numeric keypad, enter the number of the recipe that you want to save it as and press the Enter button.
At this point, Program Editing is done and the display returns back to the Menu screen.
NOTE: See Chapter 6 of this manual for some sample programs
.