Filter
Top Products
M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 31 of 31
Loop 2 Dec
Loop 2 Combo
PV 3 retrans
Loop 3 Inc
Loop 3 Dec
Loop 3 Combo
Input 1 retrans
Input 2 retrans
Input 3 retrans
Input 4 retrans
The “Offset” selection will allow the user to set the offset. This will display a numeric keypad. This will
range from –9999 to 9999.
The “Range” selection will allow the user to set the range of the output. This will display a numeric
keypad. This will range from –9999 to 9999.
Pressing the Esc key returns you to the configuration menu.
Passcode and Alarm
Parameter Value
Level 1 Code 1
Level 2 Code 2
Web Level 1 Code 111
Web Level 2 Code 222
Web Change Enable 1
No Alarm Contact is Open
Alarm Text Setup
Alarm 0 – Alarm 99 User Alarm xx
The values shown in the above table are the default values. The parameter “No Alarm” means that if there
is NO CONTROLLER ALARM, the controller alarm relay is NO. The “Level 1 Code” and the “Level 2 Code”
selections will allow the user to set the Supervisor and Administration passcodes, respectively. Either of
these options will display a numeric keypad that will range from 0 to 9999. The “Web Level 1 Code” and
the “Web Level 2 Code” selections will allow the user to set the Supervisor and Administration passcodes,
respectively, for the 9210’s web page. Either of these options will display a numeric keypad that will range
from 0 to 9999. The “Web Change Enable” selection will allow the user determine if changes can be made
to the instrument through the web page. This will display a numeric keypad that can be either 1 (Change
OK) or 0 (No Change Allowed). The “No Alarm” selection will allow the user to set what the no alarm state
is. This will display a numeric keypad that can be either 0 (Contact is Open) or 1 (Contact is Closed). This
allows the operator to assign the controller alarm as a NC contact such as a 1400°F alarm. The “Alarm
Text Setup” section will allow the user to set the alarm text for up to ninety-nine user alarms. Any of these
options will display an alphanumeric keypad.
Press the Esc key to return to the configuration menu.
IP Address
Parameter Value
IP Address 1 192
IP Address 2 168
IP Address 3 0
IP Address 4 200
IP Address Mask 1 255
IP Address Mask 2 255