Filter
Top Products
M4557 - Model 9210 Nitriding Controller
SSi Manual SERIES 9210-M4557-Nitriding Page 24 of 24
9210 to use in determining when to start/hold/stop
Soak timers in a recipe. For Nitrider applications that
do not use a Load Thermocouple, this menu can be
ignored.
Use the up and down arrow keys to highlight a specific
thermocouple. The Load TC Enable can be either:
Off, On, or On + Alarm. Pressing the Enter button
while the item is highlighted changes the current
status of that particular selection to either Active or
Inactive (blank).
Port Setup
Highlighting this menu selection and pressing the Enter button moves you to the Port Setup screen.
Warning: Changes to this screen should not be made without consulting SSi at 800-666-4330
.
Parameter Value
Host 232 Baud TPC-642S/SE
Host 232 Mode Modbus
Host 485 (3,4) Baud 19200
Host 485 (3,4) Mode Modbus
Host 485 (3,4) Address 1
Slave 1 (5,6) Baud 19200
Slave 1 (5,6) Mode Modbus
Slave 2 (22,23) Baud 19200
Slave 2 (22,23) Mode Modbus
232/H2 Port Baud 9600
These values can be changed by using the up and down arrow keys to highlight the selection. Press the
Enter button to select the item. A selection of communication protocols is displayed. Make the desired
selection and press the Enter button. The Cancel button takes you back to the previous screen without
changes being made.
Instrument Setup
WARNING: The 9210 Instrument Setup is pre-configured and tested prior to shipment. This
screen should not be changed without consulting SSi at 800-666-4330
.
The Instrument Setup screen will allow the user to set up the slave instruments. The first level allows you
to select the instrument to setup. To highlight the desired instrument use the first set of blue up and down
arrow keys and then press the Enter button. This will display a list of controllers: Atmosphere
Controllers, then Temperature Controllers, and then Miscellaneous Controllers. The Port, Address,
and Atmosphere, Temperature, Events, and Quench Assignments can also be modified from the lower
portion of the screen.
Pressing the Esc button will return you to the Menu screen.