Filter
Top Products
8
6. Plug power supply cord intoagrounded 3prong outlet.
NOTE: On somemodels, during factory testing, thetimer is
advanced partially into the cycle causing the start button to be
depressed.Allow timer to advance to the end of the cycle.
When the cycle is complete, the timer will reset and the start
button will return to the start position. If the timer is not allowed
to advance to the end of the first cycle and reset, the wash load
will notbe completed.
1. Tilt washer forward raising back legs 1" (25 mm)off of floor,to
adjustrear self-leveling legs. Gently lower washerto floor.
2. Check levelness of the washer by placing a carpenter’s level
on top of the washer, first side to side; thenfront to back.
3. If washer is not level, adjust thefront legs up or down. Make
final check with level.
4. When washer is level, use awrench to turn the nutsonfront
legsup tightly against the washer base.If nuts ar e not tight
against washer base, the washer mayvibrate.
Level the washer
CompleteInstallation
1. Check the electrical requirements. Be sure that you have the
corr ectelectrical supply and therecommendedgrounding
method.
2. Check to be sure allpartsare nowinstalled. If thereisan
extra part, go back through the stepsto see whichstep was
skipped.
3. Turn on water faucets andcheck for leaks. Tighten
couplingsifthere is leaking. Do not overtighten; this could
cause damage to faucets.
4. Check to be sureyou have allof your tools.
5. Checkthatthe shipping strapwas removedfrom the back of
the washerand used to securethe drain hose. If entire strap
is notremoved, washer may vibrateand be noisy.
Electrical Shock Hazard
Plug into agrounded3prong outlet.
Do not remove ground prong.
Do not useanadapter.
Do not usean extension cord.
Failure to followthese instructions canresult in death,
fire, or electricalshock.
WARNING