Filter
Top Products
10
IMPORT ANT
Electrostatic Discharge(ESD)
SensitiveElectronics
ESD problemsare present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished,
but failure may occur at alater date due to ESD stress.
Usean anti-static wrist strap. Connect wrist strap to green
ground connection point or unpainted metal in the washer.
-OR-
To uchyourfinger repeatedlytoagreengroundconnection point
or unpaintedmetal in thewasher.
Before removing the partfromits package, touch the
anti-static bag to agreen ground connection pointor
unpainted metal in the washer.
Avoid touching electronic parts or terminal contacts; handle
electronic control assemblyby edges only.
Whenrepackaging failed electronic control assembly in
anti-static bag, observe above instructions.
BASIC OPERATION OF COMMERCIAL WASHER
For additional information,
see www.MaytagCommercialLaundry.com.
This techsheet is notvalid formodelsprior to series MAT14.
GENERAL USER INFORMATION
Blank Display
This condition indicate the washer is inoperative. Enter set-up mode
to view diagnostic code.
‘0 Minutes’ showing in display
Thiscondition indicates the washer cannot be operated. Coins
droppedordebit inputs during this condition will be stored in escrow
butcannot be useduntil normaloperation is restored by opening
andclosing thedoor. If adoor switch fails,itmust be replaced before
normal operation can be restored.
Cold Start (initial first use)
Washer is programmed at the factory as follows:
11 minute washperiod
1 rinses and2minutesofrinse agitation
$1.75 wash price (PD models)
$0.00 wash price (PR models)
Warm Start (after power failure)
After a delay of up to 8 seconds, the washer is restored to the
state that existed at timeof the power failure.
Free Cycles
This is established by settingthe cycle pricetozero. When this
happens, ‘SELECTCYCLE’willappearratherthanacycle price.
DebitCard Ready
This washer is debit card ‘cable’ready.Itwillacceptavariety
of debitcardsystems, but does NOT comewith a debitcardreader.
Refer to thedebit card reader manufacturer forproper washer
set-up.In modelsconvertedtoaGeneration 1debit card system,
debit pulsesrepresent theequivalentofone coin (coin 1).
Display
Afterthe washer has been installed andplugged in, the displaywill
show ‘0 MINUTES’. Once thewasher has been plugged in and the
washer door opened andclosed, the display willshowthe price.In
washersset forfreecycles, the display will flash‘SELECT CYCLE’.
MINUTES
0
PRICE
2.00
ELECTRONIC CONTROLS SETUP