Filter
Top Products
7
Connect the inlethoses to the water faucets
1. Beforeattaching water inlethoses,run water through both
faucets into abucket. This will get rid of particlesin the water
lines that might clog hoses. Mark which is the hot water
faucet.
2. Attach bottom hose (inlet marked “H”) to hotwater faucet.
Tighten coupling to faucet by hand.
3. Attach top hose (inletmarked“C”)tocold water faucet.
Tightencouplingtofaucetbyhand.
4. Usepliers to make an additional two-thir ds turn to each
coupling.
Levelthe Washer
Installthe front leveling feet
1. Stack twocorner posts on top of each other. Tilt washer
backward andinsertcornerposts 3" (76 mm) in fr om oneside
of washer,asshown. Repeat with other corner posts on other
side of washer.
2. Usethe leveling legs and nuts from theparts package. Scr ew
nut downtowithin 1/2"(13 mm) of base.
3. Insert legs into correct holes at each frontcorner of washer
until nuts touchwasher.Do not tighten nuts until the washer
is leveled.
4. Tilt washer backward andremove corner posts. Gently lower
washer to floor.
5. Move washer to its permanentlocation. Remove cardboardor
hardboardfrom under washer.
If drain hoseistoo long, cut straight endofhose. (Donot cut
the “hook” shaped end of the drainhose.)
NOTE: Do not force excess lengthofdrain hose down the
standpipe. This could cause siphoning.
A
B
C
A.1/2
"
(13mm)
B. Base
C. Nut
4. Place the hoseclamp over thewasherdrain connector. Push
the drain hose onto the washer connector. Use pliers to open
clamp andslide clamp over drainhose. Check for good fit.
5. Measure and mark a point approximately 16"(406mm) from
the plug end of the shipping strap. Cut theshipping strap at
this point.
16"
(406 mm)
6. Check that hose is not twistedorkinked and is securely in
place.
7. Put “hook” end of drain hoseintostandpipe. Tightly wrap the
shipping strap around the standpipe. Push plug into the
nearest hole in the shipping strap.