Filter
Top Products
11
CONTROLSET-UPPROCEDURES
IMPORTANT: Read allinstructions before operating.
The lower fabric setting key pads and the digital display ar e used
to setup the controls. The display can contain 4 numbers and/or
letters and a decimal point. These are used to indicate the set-up
codes and related code values available for use in pr ogramming
the washer.
Howto use the key padstoprogram the controls
1. The LOWER LEFT key pad is used to adjust the values
associated with set-up codes. Pressing the key pad will
increment the value.
Rapid adjustment is possibleby holding the key pad down.
2. The LOWER MIDDLE key pad will advance you thr ough the
set-up codes. Pr essing the key padwill advance you to the
next available set-up code. Holding the key pad down will
automatically advance thr ough the set-up codes at a rate of
one (1) per second.
3. The LOWER RIGHT key pad is used to select or deselect options.
Start Operating Set-Up
�
PD Models: Insert access door key,turn, and lift to remove access door.
�
PR Models: Once the debit cardreader is installed (accor ding to the
reader manufacturer’s instructions), the set-up mode can be entered
by inserting a set-up card (supplied by the reader manufactur er) into
the car dslot. If amanual set-up cardisnot available, manual set-up
mode can be enter ed by removing connector AA1 on the circuit
board.
IMPORTANT: The console must not be opened unless poweris first
removed fr om the washer.To access connector AA1:
�
Unplug washer or disconnect power.
�
Open console, disconnect plug on AA1, close console.
�
Plug in washer or reconnect power.
The washer is now in the set-up mode.
Before proceeding,itis worth noting that, despite all of the options
available, an owner can simply choose to uncrate a new commercial
washer, hookit up, plug it in, and have a unit that operates.
SET-UP CODES
�
The LOWER MIDDLEkey pad will advance from code to code.
�
The LOWER LEFT key pad will change the code value.
�
The LOWER RIGHT key pad will select or deselect options.
FORPR MODELS: The set-up codes ar e the same as for the ‘PD’
models except wher e noted.
Theset-up code is indicated by the one or two left-hand characters. The
set-up code valueisindicated by the twoorthr ee right-hand characters.
CODE EXPLANA TION
REGULAR CYCLEPRICE
Represents the numberofquarters (coin 1);may adjust from 0-39.
(See VALUE OF COIN 1.)Advance from 0-39bypressing the LOWER
LEFT key pad.Factorypreset for 7quarters = $1.75.
PR MODELS ONLY:Factory preset for 0 quarters.
�
Press theLOWER MIDDLE key pad oncetoadvance to next code.
607
CODE EXPLANA TION
WASH LENGTH
This is thenumber of minutesfor WASH.
Choose from 8-20 minutesbypressing the LOWER LEFTkey pad.
�
Press the LOWER MIDDLE keypad once to advance to next code.
RINSECYCLES
This is thelength and total numberof rinses. Each rinse agitation is
1-4minutes, withachoiceof1or 2rinses.The middle digit is the
lengthof rinseagitatio nand the right digit is the number of rinses.
The number is changed in the followingsequence (11,21, 31,41,
12, 22,32, 42) by pressing the LOWER LEFT key pad.
Pressthe LOWER MIDDLE keypad once to advance to next code.
The DELICA TES &KNITScycle hasafixed rinse agitation length
of oneminute.
�
Press the LOWER MIDDLE keypad once to advance to next code.
CYCLECOUNTER OPTION
This option is either SELECTED ‘ON’ or NOT SELECTED‘OFF’.
Not Selected ‘OFF’.
Selected‘ON’ and not able to be deselected.
Press the LOWER RIGHTkey pad3consecutive times
to select ‘ON’.Once selected ‘ON’ it cannot be deselected.
�
Press the LOWER MIDDLE keypad once to advance to next code.
MONEY COUNTEROPTION
This option is either SELECTED ‘ON’ or NOT SELECTED‘OFF’.
Not Selected ‘OFF’.
Selected‘ON’.
Press the LOWER RIGHTkey pad3consecutive times
to select ‘ON’ and3consecutive times to remove
(Not Selected ‘OFF’.) Counter resets by going from ‘OFF’to‘ON’.
Selected ‘ON’and notable to be deselected.
To select ‘ON’ andnot able to be deselected, first select‘ON’, then
withintwo seconds pressthe LOWER RIGHT key pad twice,the
LOWER LEFT key pad once,and exit the set-up mode.
�
Press the LOWER MIDDLE keypad once to advance to next code.
SPECIAL PRICING OPTION
This option is either SELECTED ‘ON’ or NOT SELECTED‘OFF’.
Not Selected ‘OFF’.
Selected‘ON’. Pressthe LOWER RIGHTkey pad once
forthis selection.
If SPECIAL PRICINGOPTIONisselected,you have access to codes ‘3.’
through ‘9.’.
�
Press the LOWER MIDDLE keypad once to advance to next code.
711
607
711
900
900
90
C
1. 00
1. 00
1. 0
C
1.
C
0
2. 00
2. 00
2.
SP
OPTIONSTOUSE IF SPECIAL PRICINGISSELECTED:
SPECIAL CYCLE PRICE
Representsthe numberof quarters (coin 1): may adjust
from 0-39.(SeeVALUE OFCOIN 1.) Advance from 0-39 by
pressing theLOWER LEFT keypad.Factory preset
for7quarters=$1.75.
PR MODELS ONLY:Factory preset for0quarters.
�
Pressthe LOWER MIDDLE keypad once to advance to next code.
3. 07
3. 07
821
821