Filter
Top Products
6
Connect thedrain hose
NOTE: Slide washer onto cardboardor hardboard before
moving across floor.
1. Move washer closeto final position.
2. Put“hook” endof drain hose into laundry tubor standpipe.
3. Estimate the lengthofdrain hose needed when washer is in
finalposition. Hose must be cut exactly to lengthso“hook”
end is heldtightly over edge of standpipe.
Remove Shipping Strap
1. Remove tape that covers shippingstrap. Pull to completely
remove the shipping strap with 2 cotter pins from the inside of
the washer.
2. Pull firmly to remove the end of shipping strap from the back
of the washer. The shipping strapplug must be completely
removed from the washer forthe self-leveling legs to be
released.
Save the shipping strap for later use.
INSTALLATION INSTRUCTIONS
WARNING
Excessive Weight Hazard
Use twoormorepeople to move and install washer.
Failuretodoso can result in back or other injury.
A
B
A. Shipping tape
B. Shipping strap
A
B
A. Coupling
B. Washer
Connectthe Hoses
Proper connection of the drain hose avoids damage to your oors
dueto water leakage. Read and follow these
instructions.
Connect the inlet hosestothe washer
1. The washer must be connected to the water faucets using
thenew inlet hoses. Do not use old hoses. Insert new flat
washers (supplied) into each end of the inlet hoses. Firmly
seat the washers in the couplings.
2. Attach hose to bottom inlet valve opening first.
3. Attach second hose to top inlet. Tighten couplings by hand;
then use pliers to makean additional two-thirds turn.
NOTE: Inlet valve threads are plastic. Do not strip or cross-
thread.
A
B
A. Cold water inlet valve
B. Hot water inletvalve