Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Service removal 60
14. MAINTENANCE
- Before performing any work on the washing machine, disconnect and mechanically lock the external
switch, and close and mechanically lock the manual water inlet valves.
- Check the temperature of the parts to be handled, to avoid the risk of burns.
- The dispenser may contain residues of chemical products. When handling this component, avoid direct
contact with the skin and use eye protection.
- The draining pump and valve may contain residual water. When handling this component, avoid direct
contact with the skin and use eye protection.
- Remember to reassemble ALL of the panels and place them correctly after any maintenance work.
- It is highly recommendable asking the Authorised Technical Service a register or report of all the
maintenance and service work done on your washer.
14.1. OPERATIONS DESCRIBED
Cleaning the washer
Cleaning the door seal
Cleaning the electro valve filters
Cleaning the dispenser
Revising the safety mechanisms
General Revision
Recovery tank cleaning
14.2. WASHING MACHINE CLEANING
We recommend periodic cleaning of the outside of the washing machine. Use a damp cloth or
sponge.
To remove traces of grease, use mild soap and rinse as required.
Never use abrasive products or tools that could scratch or damage the surface of the washing
machine.
14.3. DOOR SEAL CLEANING
Use a damp cloth or sponge.
Be especially careful to remove traces of laundry products or pieces of fabric that could be caught
between the folds of the seal.
Never use abrasive products or tools that could cut or damage the seal.
14.4. CLEANING THE ELECTRO VALVE FILTERS
Only by qualified personnel.
Required tools:
Disassembly of the fittings: slip-joint pliers or pipe wrench 35mm.
Disassembly of the filter supports: wrench 34 mm
Disassembly of the filters: pliers.
Steps to follow
Disconnect and mechanically lock the external switch. Close and mechanically interlock the manual
water supply valves.
Check the temperature of the hot water inlet hose, so as to avoid the risk of burns.
Disassemble the fittings that connect the hoses to the washing machine.