Filter
Top Products
Cod. G522441
© Copyright 2009, Alliance Laundry System LLC – DO NOT COPY OR TRANSMIT Rev. 02/0510
Executing programs 16
4.9. UNBALANCE CONTROL
Before starting spin, the electronic control of the washing machine checks the correct distribution of the load.
If it detects that the load is not well distributed and that can cause an excessive unbalance during the spin, a new
positioning of the clothes will be carried out.
If there’s still unbalance during the spin of the last phase, the washer can end the washing cycle reducing the
spin speed.
Three unbalance levels, which cause different reactions in the washing machine, have been established.
The unbalance level detected is viewed on the INFO screen when the washing machine executes the spin cycle.
NO unbalance:...........allows any spin cycle
LOW unbalance:........allows medium speed spin cycles and high speed spin cycles after a certain number
of attempts.
MEDIUM unbalance:..allows medium speed spin cycles; after a certain number of attempts, it reduces the
speed of the high spin cycles
HIGH unbalance: .......does not allow the spin cycle
As a safety feature, a microswitch monitors the movement of the washer suspended group. It is only activated in
cases of extreme unbalance. This device prevents executing spin cycles.
To improve the efficiency of the spin of the washer it’s advisable to:
Load the washing machine up to its nominal value, using the total capacity of the drum.
Load the washer with homogeneous loads
4.10. MACHINES WITH TILT SYSTEM
The TILT SYSTEM is made up of a pneumatic actuators system and an auxiliary electric control that allows the
tilting of the washer forwards and backwards to assist loading and unloading while the door of the machine is
open.
At the same time, operating the corresponding control devices, the drum rotation at low speed can be started.
With the machine at the loading position, a water inlet can be opened (cold or hot) to soak the dry linen and
reduce its volume. The maximum water level allowed in this situation is limited by program. The water used
during this process will be kept inside the washer when a new cycle is started. To drain the water used during
the loading process, turn off and on again the O/I switch on the control panel of the machine.
To use the TILT system control, the optionalA10 (TILT) board must be installed and appropriately activated on
the SETUP menu.