Filter
Top Products
OPERATION INTRAC-305
Page 46 INTRAC-305 MANUAL - Issue 3.2 ©2011 Advantech Wireless
SHOW ALARMS
1
2
3
4
5
6
puts the antenna control system into
STANDBY mode and skips to the HOME
menu
skips to the Home (root) menu
updates the Show Alarms display
attempts to reset all latched alarms and
clears Alarms display
shows the previous page of alarms (if
there is more than one page)
shows the next page of alarms (if there
is more than one page)
Alarm Code
00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00
Beacon Alarm (SEC)
Hardware Fault
Servo Alarm (SEC)
Az Soft Limit
El Soft Limit
Unable to Predict (SEC)
Polar Soft Limit CW
Polar Soft Limit CCW
Emergency Stop
Model Expire
Remote Jog Time-out
>More<
Standby
Home
Update
Alarms
Clear
Alarms
(Previous
Page)
Next
page
Function
Path HOME - SHOW ALARMS (Menu Key 5)
Description This screen shows all the currently active alarms, both
primary and secondary. If there are more alarms active than
can be displayed on one page “MORE” is appears at the
bottom of the screen. Menu Keys 5 & 6 can then be used to
move through the pages of alarms. If there is only one page
of alarms Menu Keys 5 & 6 are not labelled.
Primary alarms will cause the System Alarm indicator to
illuminate drawing attention to the fact that an alarm has
become active. Secondary alarms do no illuminate the
indicator but will still be displayed on the alarms screen even
if there are no primary alarms.
Note The alarm conditions do not update automatically whilst being
displayed. To check if an alarm state has changed press
Menu Key 4 (Clear Alarms) to clear the display. Follow this
by pressing Menu Key 3 (Update Alarms) to display the
current alarm state.