Filter
Top Products
INTRAC-305 OPERATION
© 2011 Advantech Wireless INTRAC-305 MANUAL - Issue 3.2 Page 27
3
BEACON THRESHOLD
1
2
3
4
5
6
puts the antenna control system into
STANDBY mode and skips to the HOME
menu
skips to the Home (root) menu
skips to the Models menu
skips to the Config menu
skips to the System Setup menu
(not used)
Current Mode Tracking
Control State Local
Beac Freq 11.452000 GHz
Beac Level -10.05 dB
El Angle 25.37
o
Az Angle 210.50
o
Pol Angle 27.4
o
Standby
Home
Models
Config
System
Setup
Function
Set Level: -14.12 dB
Press EN to accept selection
Path HOME - FUNCTION - MENU KEY 6 (x8) - ENTER
or From Models or System Setup
CONFIG - MENU KEY 6 (x8) - ENTER
Description On this screen the beacon signal strength at which the
beacon level alarm trips is set.
If the tracking signal level falls below the value set here the
INTRAC-305 considers the tracking signal receiver to have
lost lock on the beacon.
Edit the value in the “Set Level” box using the numeric
keypad. The & move the cursor.
Note The only function of the beacon level alarm is to operate a
relay for external use. It is not used by the INTRAC algorithm
and, when it occurs in isolation without an alarm from the
IBR-L, has no effect on the INTRAC operation or mode.