Filter
Top Products
INTRAC-305 OPERATION
© 2011 Advantech Wireless INTRAC-305 MANUAL - Issue 3.2 Page 21
3
FUNCTION (Configuration)
1
2
3
4
5
6
puts the antenna control system into
STANDBY mode and skips to the
HOME menu
skips to the Home (root) menu
skips to the Models menu
controls whether ‘Angles’ or
‘Diagnostics’ appear on Test Port 1
skips to the System Setup menu
moves the highlight box to the next field
in the current menu
Current Mode Tracking
Control State Local
Beac Freq 11.452000 GHz
Beac Level -10.05 dB
El Angle 25.37
Az Angle 210.50
Pol Angle 27.4
Standby
Home
Models
Test
Port-1
Diags
System
Setup
Function
Press EN to accept selection
Next
Field
> Beacon Pol not avail <
Beacon Frequency
Edit Satellite Table
Soft Limits
x2 Setup
Diagnostics On
Diagnostics Off
Beacon Threshold
Path HOME - MENU KEY 4
Note There are three separate menus under the FUNCTION
heading. Pressing Menu Key 4 (FUNCTION) on the “Home“
menu leads to the CONFIGURATION menu from which the
MODELS menu and the SYSTEM SETUP menu are reached
via Menu Keys 3 & 5 respectively.
This Configuration menu can also be reached by Menu Keys
from the MODELS & SYSTEM SETUP menus
Description The Configuration menu contains seven sub menus plus
Diagnostics On & Off.
The sub menus are described on the following pages.
The Diagnostics On & Off keys are used to route the INTRAC
diagnostic data to the Remote Control port. This facility
enables one PC to be used as both the remote control
terminal and the diagnostics receiving terminal. However it
cannot do both at the same time.
WHEN IT IS REQUIRED TO CONTROL THE INTRAC FROM
THE REMOTE TERMINAL DIAGNOSTICS MUST BE
SWITCHED OFF.
Menu Key 4 Test Port - 1 Diags (Angles)
The data available at Test Port - 1 is either INTRAC
diagnostic data (the same diagnostic data as mentioned
above) or angles data. Selection between these two is by
Menu Key 4 whose label toggles between “Diags” & “Angles”