Filter
Top Products
INTRAC-305 OPERATION
© 2011 Advantech Wireless INTRAC-305 MANUAL - Issue 3.2 Page 19
3
AUTO CONTINUE
1
2
3
4
5
6
moves to the Manual/Stow menu
moves to the 1st ‘Goto’ menu ie Goto
Position
resumes tracking using the INTRAC’S
current model
clears the INTRAC’S current model and
starts learning a new model
New Mode
Auto
New
Model
Goto
Standby
Auto
Continue
Manual
/Stow
puts the antenna control system into
STANDBY mode and skips to the HOME
menu
Beac Level
Beac Freq
El Angle
Az Angle
Pol Angle
Local
Current Mode
Home
skips to the Home (root) menu
Path HOME - NEW MODE - MENU KEY 5
Description This facility does not have a screen of its own. It is a function
enabled by a menu key on the New Mode menu.
If the INTRAC had been in Learning or Tracking mode and
had been taken out of that mode, and the model was still
valid, pressing Auto Continue will return the INTRAC to that
mode.
The antenna may have been stowed or moved off satellite for
some other reason. Alternatively the INTRAC may have gone
into Standby due to an alarm. In either case (once the
antenna has been unstowed) pressing Auto Continue will
cause the antenna to drive back to the satellite and continue
Learning or Tracking.
If the INTRAC had been Tracking but the time off satellite was
too long for the model to be relied on it will restart in Learning
mode to build a new model.
Note Until and unless the orbit model is cleared pressing Auto
Continue will cause the antenna to be driven to the satellite of
that model. Thus if a new satellite is required to be tracked
the antenna must be driven to that satellite’s location and
“Auto New Model” used to cause the INTRAC clear the
existing model and start to build a new one.
(see Auto New Model on the next page)