72 Strain Relief Cable Clamps
VX5 User’s Guide E-EQ-VX5OGWW-F-ARC
Strain Relief Cable Clamps
Equipment Required: Phillips screwdriver (not supplied by LXE)
There are four strain relief cable clamps secured to the bottom of the VX5. Use the strain relief
clamps to secure audio, power, and I/O cables attached to the VX5.
T10A, 125V
INPUT:
12-80VDC
6A 72W
ETHERNET /
USB
KEYBOARD /
MOUSE
COM2/3COM1 / SCANNER
UDIO
N107
REFER TO
MANUAL
IP66
LISTED
I.T.E.
E-130794
C
PRODUCT OF U.S.A. U.S. PATENT 5862393
US
U
L
®
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This Clas s A digit al apparatus com plies with
Canadian ICE-003.
Cet appare il num de la Cla sse A est
confirme là n
érique
orme NMB -003 du Canada
CAUTION: For co ntinues protection against r isk of fire,
replace only with same type and rating of f use.
ATTENTION: Pour ne pas compromette la preotectio n
contre les risques d'incendie, rempl acer par un fusible
de mêmes types de mêmes caractéristques nomi nales.
!
Figure 72 Strain Relief Cable Clamps
1. Remove the strain relief clamp from the bottom of the VX5 by turning the screw
counterclockwise. Put the screw aside in a safe location.
2. Slide the strain relief clamp over the cable.
Figure 73 Slide Clamp Over Cable
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the
cable to the VX5. Do not stretch the cable. Leave enough slack in the cable to allow it to be
connected and disconnected easily when needed.
4. Continue in this manner until all cables are secured to the VX5.
