60 Connect Ethernet Cable
VX5 User’s Guide E-EQ-VX5OGWW-F-ARC
Connect Ethernet Cable
An Ethernet connector is available via a dongle cable attached to the port marked
“ETHERNET/USB”, located on the bottom of the VX5.
2
3
1
1 D15 Connector
2 RJ45 Connector
3 USB Connector
Figure 58 VX5 Ethernet/USB Dongle Cable
T10A, 125V
INPUT:
12-80VDC
6A 72W
ETHERNET /
USB
KEYBOARD /
MOUSE
COM2/3COM1 / SCANNER
UDIO
N107
REFER TO
MANUAL
IP66
LISTED
I.T.E.
E-130794
C
PRODUCT OF U.S.A. U.S. PATENT 5862393
US
U
L
®
THIS DEVICE COMPLI ES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEV ICE MAY NOT CAUSE HARMF UL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OP ERATION.
This Clas s A digita l apparatus comp lies with
Canadian ICE-003.
Cet appareil num de la Classe A est
confirme là n
érique
orme NM B-003 du Canada
CAUTION: For continues protection against risk of fire,
replace only with same type and rating of fuse.
ATTENTION: Pour ne pas compromette la preotection
contre les risques d'incendie, remplacer par un fusible
de mêmes types de mêmes caractéristques nominales.
!
Figure 59 Connect Ethernet/USB Dongle Cable
1. Insert the watertight-connector end of the Ethernet/USB dongle cable into the VX5
Ethernet/USB connector. Seat the connector firmly over the pins and turn the
thumbscrews in a clockwise direction. Do not over tighten.
2. Use a strain relief clamp to secure the cable.
Figure 60 Connect Ethernet Cable to Adapter Cable
3. Insert the network cable and ensure it is firmly seated in the connector jack.
4. To remove the Ethernet cable, press the release tab on the cable end.
