44 Install Mounting Brackets
VX5 User’s Guide E-EQ-VX5OGWW-F-ARC
Step 3 - Attach VX5 Assembly To Bottom Mounting Bracket.
1. Place lock washer first, then flat washer on 1/4-20x5/8 bolt. Next insert mounting bolts
through the curved apertures in the bottom mounting bracket and into the screw holes in
the side bracket.
Figure 39 Attach VX5 Assembly to Bottom Bracket
2. Loosely tighten each bolt as it is inserted.
Important: Do not torque bolts until all bolts are in place and viewing angle
is adjusted.
3. Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX5.
4. Torque the hex bolts to 50±5 lbf.in (5.64±.56 N.m).
Note: Test the torque on the bolts frequently during operation and re-tighten if
necessary to 50±5 lbf.in (5.64±.56 N.m).
5. Adjust the angle of the keyboard (if the integrated keyboard mounting bracket is used) by
loosening the two adjusting knobs, adjusting the keyboard angle and then tightening the
adjusting knobs.
