Connect Serial Barcode Scanner 55
E-EQ-VX5OGWW-F-ARC VX5 User’s Guide
Connect Serial Barcode Scanner
!
Refer to the documentation received with the barcode scanner for complete
instructions. Read all warnings and caution labels.
Pin 9 of COM1 is configured to provide +5V. Pin 9 of COM2 is configured to provide RI. To
change Pin 9 of either port, please refer to the “VX5 Reference Guide”.
The scanner cable is attached to the connector marked “COM1/SCANNER”. The scanner receives
power from the VX5.
The cable requires a nine-pin D-shell female connector for the VX5.
Note: Use of a shielded cable is required to maintain FCC and CISPR22 emissions
compliance.
T10A, 125V
INPUT:
12-80VDC
6A 72W
ETHERNET /
USB
KEYBOARD /
MOUSE
COM2/3COM1 / SCANNER
UDIO
N107
REFER TO
MANUAL
IP66
LISTED
I.T.E.
E-130794
C
PRODUCT OF U.S.A. U.S. PATENT 5862393
US
U
L
®
THIS DEVICE COMPLI ES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEV ICE MAY NOT CAUSE HARMF UL
INTERFERENCE, AND (2) THIS DEV ICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This Clas s A digita l apparatus comp lies with
Canadian ICE-003.
Cet appareil num de la Classe A est
confirme là n
érique
orme NM B-003 du Canada
CAUTION: For continues protection against risk of fire,
replace only with same type and rating of fuse.
ATTENTION: Pour ne pas compromette la preotection
contre les risques d'incendie, remplacer par un fusible
de mêmes types de mêmes caractéristques nominales.
!
Figure 51 Connect Serial Scanner Cable
1. Seat the connector firmly over the pins and turn the thumbscrews in a clockwise
direction. Do not overtighten.
2. Use a strain relief clamp to secure the cable.
